650evl chainsaw pdf manual

The 650EVL Chainsaw is a professional-grade electric chainsaw designed for heavy-duty cutting tasks. It features a powerful 15-amp motor, 20-inch Oregon bar and chain, automatic oiling system, tool-free chain tensioning, low-kickback design, and safety features including chain brake and hand guard. Below are key sections for safety, features, assembly, operation, maintenance, and troubleshooting.

Features at a Glance

Key components: 15-amp electric motor, 20-inch Oregon bar and chain, automatic oiling system, chain brake, tool-free tensioning, rear handle with safety trigger, front hand guard.

Safety Instructions

Always wear proper safety gear and follow safety guidelines.

1. Personal Protective Equipment: Wear safety glasses, hearing protection, gloves, chainsaw chaps, and steel-toe boots.
2. Work Area Safety: Clear area of obstacles; ensure secure footing; keep bystanders away.
3. Electrical Safety: Use grounded outlet; keep cord away from cutting area; do not use in wet conditions.
4. Chain Safety: Always engage chain brake when not cutting; keep chain sharp and properly tensioned.

WARNING! Never operate chainsaw with one hand. Always maintain firm grip with both hands.

Assembly & Setup

Unpack and assemble chainsaw before first use.

1. Attach guide bar: Place bar onto mounting studs, align chain sprocket.
2. Install chain: Position chain on bar with cutting teeth facing forward.
3. Tension chain: Use tensioning wheel to achieve proper tension (chain should snap back when pulled).
4. Fill oil reservoir: Use bar and chain oil only; check level before each use.
5. Plug in: Connect to grounded 120V outlet; test chain brake operation.

CAUTION! Ensure chain is properly installed and tensioned before operation.

Specifications

• Motor: 15-amp electric
• Bar Length: 20 inches
• Chain Pitch: 0.325 inches
• Chain Gauge: 0.050 inches
• Oil Capacity: 8.5 oz
• Weight: 12.5 lbs
• Cord Length: 12 feet
• Voltage: 120V AC, 60Hz
• Sound Level: 105 dB(A)
• Warranty: 2-year limited

Controls and Operation

Main controls: Safety trigger, throttle lockout, chain brake, tensioning wheel, oil fill cap.

Starting Procedure:

1. Check oil level and chain tension
2. Place on flat surface
3. Press safety trigger lockout
4. Squeeze trigger to start
5. Test chain brake before cutting

Stopping: Release trigger; engage chain brake; unplug from outlet.

Chain Maintenance

Proper chain maintenance ensures optimal performance and safety.

1. Sharpening: Use round file (5/32") at 30° angle; file each tooth evenly.
2. Tensioning: Chain should be snug against bar but pull freely; adjust when warm.
3. Lubrication: Check oil flow before each use; refill as needed.
4. Cleaning: Remove sawdust from oil ports and bar groove regularly.

Tip: Always wear gloves when handling chain.

Cutting Techniques

Follow proper techniques for safe and efficient cutting.

1. Felling: Plan escape path; make notch cut; then back cut leaving hinge.
2. Limbing: Work from trunk outward; keep saw between you and branch.
3. Bucking: Support log properly; cut from top down; avoid pinching.
4. Pruning: Cut small branches first; support larger branches.

WARNING! Beware of kickback; never cut with tip of bar.

Troubleshooting

Service: For repairs, contact authorized service center.

Storage & Care

Proper storage extends chainsaw life.

1. Clean thoroughly after each use
2. Drain oil reservoir for long-term storage
3. Store in dry place, protected from moisture
4. Cover bar and chain to prevent rust
5. Check condition before next use

CAUTION! Never store with fuel in tank (if applicable).

Warranty Information

2-year limited warranty covering defects in materials and workmanship. Warranty does not cover normal wear, misuse, or unauthorized repairs. For warranty claims, contact manufacturer with proof of purchase. Keep this manual for reference.